Installation Instructions
P-100 PUTTER
Heads
Cut shaft
at 5.625” HEIGHT (not length - measure height at resting lie angle)
Abrade shaft
0.625” of trimmed section
Clean abraded shaft tip
(acetone recommended)
Abrade inside
of Putter Hosel Adapter
Clean inside
(cotton swab and acetone recommended)
Apply epoxy
to shaft tip and inside of adapter
MUST install adapter onto shaft
with indicator line parallel to the putter face
Wipe excess epoxy
Allow epoxy to fully
cure before handling again
Heads
Cut shaft
at 5.625” HEIGHT (not length - measure height at resting lie angle)
Abrade shaft
0.625” of trimmed section
Clean abraded shaft tip
(acetone recommended)
Abrade inside
of Putter Hosel Adapter
Clean inside
(cotton swab and acetone recommended)
Apply epoxy
to shaft tip and inside of adapter
MUST install adapter onto shaft
with indicator line parallel to the putter face
Wipe excess epoxy
Allow epoxy to fully
cure before handling again
Shafts
Must reference previously built head w/ p-100
Cut shaft
at 5.625” HEIGHT (not length - measure height at resting lie angle)
Abrade shaft
0.625” of trimmed section
Clean abraded shaft tip
(acetone recommended)
Abrade inside
of Putter Hosel Adapter
Clean inside
(cotton swab and acetone recommended)
Apply epoxy
to shaft tip and inside of adapter
MUST install adapter onto shaft
with indicator line parallel to the putter face
Wipe excess epoxy
Allow epoxy to fully
cure before handling again
Shafts
Must reference previously built head w/ p-100
Cut shaft
at 5.625” HEIGHT (not length - measure height at resting lie angle)
Abrade shaft
0.625” of trimmed section
Clean abraded shaft tip
(acetone recommended)
Abrade inside
of Putter Hosel Adapter
Clean inside
(cotton swab and acetone recommended)
Apply epoxy
to shaft tip and inside of adapter
MUST install adapter onto shaft
with indicator line parallel to the putter face
Wipe excess epoxy
Allow epoxy to fully
cure before handling again