Installation Instructions
FAZ-FIT FAIRWAY WOODS & HYBRIDS
SHAFTS
1
STANDARD TIP TRIM
1.25” plus OEM recommended trim (allow 1.5” parallel section)
2
SHAFT PREPARATION
- Abrade shaft tip 0.75” (remove all paint from tip section)
- Clean abraded shaft tip (acetone recommended)
3
ADAPTER PREPARATION
- Abrade inside of Faz-Fit Shaft Adapter
- Clean inside (cotton swab and acetone recommended)
4
INSTALLATION
- Fully mix 2-part epoxy (golf club specific – other epoxies NOT recommended)
- Fully coat inside of adapter and outside of shaft tip with epoxy
- Insert shaft into adapter (NOTE: shafting beads may be needed for better fit)
- Rotate to desired position (Default: shaft logo aligned with “dot(s)” on adapter)
- Tamp until shaft tip reaches full depth of adapter
- Wipe off excess epoxy on outside of shaft and adapter
- Allow epoxy to fully cure before handling again
5
FINISHING
- Fairway Wood – butt trim to desired length (w/o head)
- Butt trim to 41” (w/o head) = 43” (total length w/ head)
- Convert length appropriately (e.g. 40.5” = 42.5”, etc.)
- Hybrid – butt trim to desired length (w/o head)
- Butt trim to 38” (w/o head) = 40.25” (total length w/ head)
- Convert length appropriately (e.g. 37.25” = 39.5”, etc.)
- Affix head to shaft, then measure CPM (no grip; 5” clamp at 40 psi)
- Install grip to desired position (Default: align grip logo with shaft logo)
- Label shaft with length and CPM (Default: 0.5” below grip, opposite of logos)
HEADS
Must reference previously built shaft w/ Faz-Fit
1
ALTERATION
Head weight with all Faz-Fit components should equal OEM weight
- Record OEM weight of head (w/ OEM adjustable adapter if applicable)
- Remove OEM ferrule (if applicable)
- Dry fit Faz-Fit Hosel Adapter w/ Nut into hosel
- Affix dry fitted head to shaft (previously built w/ Faz-Fit)
- Measure total length
- Measure the difference of labeled shaft length to actual club length
- Cut the difference in length from the hosel (if possible)
- Record weight of head, Faz-Fit Shaft & Hosel Adapter w/ Nut
- Add or relieve weight (if possible) to match original OEM weight
2
INSTALLATION
Bonding Faz-Fit Hosel Adapter w/ Nut and head
- Abrade inside of hosel
- Abrade Faz-Fit Hosel Adapter
- Clean all abraded surfaces (acetone recommended)
- Fully mix 2-part epoxy (golf club specific – other epoxies NOT recommended)
- Fully apply a light coat of epoxy inside the hosel
- Feed Hosel Adapter through Nut
- Insert Faz-Fit Hosel Ad. Install Tool into Hosel Adapter
- Carefully apply epoxy to the portion of Hosel Adapter that inserts the hosel
- Insert fully into hosel
- Align indicator line on Faz-Fit Hosel Ad. Install Tool parallel to club face
- Wipe excess epoxy (NO NOT LEAVE EPOXY ON ANY THREADINGS)
- Remove Install Tool
- Allow epoxy to fully cure before handling again