OEM specifications

• Abrade shaft tip 0Abrade shaft tip 2”
• Clean abraded shaft tip (acetone recommended)

• Abrade inside of Fuse-Fit Shaft Adapter
• Clean inside (cotton swab and acetone recommended)

(bonding Fuse-Fit Shaft Adapter and shaft)

• Fit o-ring onto shaft tip (roll it up the shaft to allow room for the rest of install)
• Slip Fuse-Fit Nut onto shaft until it reaches o-ring (careful not to scratch shaft)
• Temporarily tape Fuse-Fit Nut in place
• Fully mix 2-part epoxy (golf club specific – other epoxies NOT recommended)
• Apply a thin layer of epoxy to the general install area of the shaft
• Carefully apply epoxy to the inside of Fuse-Fit Shaft Adaptor
• Apply shafting beads (if necessary)
• Install Shaft Adapter until top (flat end) reaches 2.125” up the shaft tip
• Rotate to desired position (Default: indicator line opposite of shaft logo)
• Wipe off excess epoxy (DO NOT leave epoxy in corners of Shaft Adapter)
• Allow epoxy to fully cure before handling again
• Remove masking tape and push o-ring and nut toward Shaft Adapter

• Irons – butt trim to desired length (w/o head)
  • Butt trim to 36.125” (w/o head) = 37.5” (total length w/ head)
  • Convert length appropriately (e.g. 35.625” = 37”, etc.)
• Wedges – butt trim o desired length (w/o head)
  • Butt trim to 33.25” (w/o head) = 35.25” (total length w/ head)
  • Convert length appropriately (e.g. 33.75” = 35.75”, etc.)
• Affix head to shaft, then measure CPM (no grip; 5” clamp at 40 psi)
• Install grip to desired position (Default: align grip logo with shaft logo)
• Label shaft with length and CPM (Default: 0.5” below grip, align w/ logos)

Head weight with all Fuse-Fit components should equal OEM weight

• Record OEM weight of head (without ferrule – if applicable)
• Dry fit Fuse-Fit Hosel Adapter over hosel with size AA, A, B, or C
• Affix dry fitted head to shaft (previously built w/ Fuse-Fit)
• Measure total length
• Measure the difference of labeled shaft length to actual club length
• Cut the difference in length from the hosel (if possible)
• Drill to lower bore depth (if necessary)
• Record weight of head, Fuse-Fit Hosel Adapter, and Fuse-Fit Shaft Adapter Kit
• Add or relieve weight (if possible) to match original OEM weight

Bonding Fuse-Fit Hosel Adapter and hosel

• Abrade outside of hosel
• Abrade inside of Fuse-Fit Hosel Adapter (until black is removed from inside)
• Clean all abraded surfaces (acetone recommended)
• Fully mix 2-part epoxy (golf club specific – other epoxies NOT recommended)
• Apply epoxy to abraded portion of hosel and inside of Hosel Adapter
• Place Fuse-Fit Hosel Adapter over hosel
• Align indicator line on Fuse-Fit Hosel Adapter parallel to club face
• Wipe excess exterior epoxy (NO NOT LEAVE EPOXY ON THREADINGS)
• Allow epoxy to fully cure before handling again
• Use a .370 reamer bit to clear excess epoxy and material from inside hosel